Back to Contents Page

Hardware Specifications

Dell™ Remote Access Controller Installation and Setup Guide

  Power Requirements

  PCI Interface

  Connectors

This section provides information on the hardware attributes and characteristics of the RACs, including power requirements, PCI interfaces, and connectors.

Power Requirements

DRAC III

Table A-1. DRAC III Power Requirements

DRAC III Power Supply Specifications

• Input: 110-240 V, 50-60 Hz, 35-42 vA
  
  
• Output: +6 V, 2.5 A
  
  

DRAC III/XT

System power: +5 V Standby at 1.1 A maximum

ERA/O

System power: +2.5 V at 2 A maximum

PCI Interface

DRAC III

The DRAC III is compliant with PCI Local Bus Specification 2.1. Table A-2 provides the identification values for the card.

Table A-2. DRAC III Identification Values

Connectors

DRAC III

The DRAC III connectors are summarized in Table A-3.

Table A-3. DRAC III Connectors

DRAC III/XT

The DRAC III/XT provides an RJ-45 NIC connector and a 10-pin VT-100 serial connector (not currently supported).

ERA

The ERA provides an RJ-45 NIC connector (on the system board).

ERA/O

The ERA/O provides an RJ-45 NIC connector (on the system board).

Back to Contents Page